TPS2343DDPR

595-TPS2343DDPR
TPS2343DDPR

Fabr.:

Descripción:
Controladores de voltaje de cambio en caliente Dual Slot PCI-X 2.0 Hot-Plug Pwr Cntrlr

Ciclo de vida:
Obsoleto
Modelo ECAD:
Descargue el Cargador de bibliotecas gratuito para convertir este archivo para su herramienta ECAD. Obtenga más información del modelo ECAD.
Actualmente Mouser no vende este producto en su región.

Disponibilidad

Existencias:

Atributo del producto Valor del atributo Seleccionar atributo
Texas Instruments
Categoría de producto: Controladores de voltaje de cambio en caliente
Restricciones de envío:
 Actualmente Mouser no vende este producto en su región.
RoHS:  
PCI Power Management
1.25 A
13.2 V
10.8 V
2 Channel
3 mA
- 40 C
+ 85 C
SMD/SMT
HTSSOP-80
Reel
Cut Tape
MouseReel
Yes
Marca: Texas Instruments
Sensibles a la humedad: Yes
Tipo de producto: Hot Swap Voltage Controllers
Serie: TPS2343
Cantidad del paquete de fábrica: 2000
Subcategoría: PMIC - Power Management ICs
Peso unitario: 262,400 mg
Productos encontrados:
Para mostrar productos similares, seleccione al menos una casilla
Seleccione al menos una casilla para mostrar productos similares dentro de esta categoría.
Atributos seleccionados: 0

TARIC:
8542399000
CNHTS:
8542319000
USHTS:
8542390090
MXHTS:
85423999
ECCN:
EAR99

LM5060 High-Side Protection Controllers

Texas Instruments LM5060 High-Side Protection Controllers with Low Quiescent Current offers intelligent control of a high-side N-channel MOSFET during normal on/off transitions and fault conditions. The constant rise time of the output voltage results from the inrush current control. Both an Input UVLO (with hysteresis) and a programmable input OVP are provided, with an enable input offering a remote on or off control. The initial start-up VGS fault detection delay time, the transition VDS fault detection delay time, and the continuous over-current VDS fault detection delay time is programmed from a single capacitor. The MOSFET is latched off until either the enable input, or the UVLO input is toggled low and then high when a detected fault condition persists longer than the allowed fault delay time.